PV Mounting System for Flat Roofs
Unirac’s universal ballasted flat roof solution
accommodates a wide range of modules and requires very few or no
penetrations, depending on location and building codes. Minimal parts,
faster installation, reduced labor expenses and versatility; all
customer-driven demands that helped engineer this unique flat roof solution.
The RapidRac G10 was developed through significant computational
fluid dynamics and wind tunnel engineering. The efficient design, built at a
fixed 10 degree tilt angle, optimizes natural convective cooling of the
modules and was designed to meet the requirements of current applicable
building codes.
You can minimize your system costs by making your columns as long as
possible. Each roof is unique and the array layout will have to be designed
for the particulars of each roof.
Unirac offers an attachment option for the RapidRac G10, the
RapidFoot, which can be used for seismic restraint and for ballast trade
off, allowing for a reduction in roof dead load.
10-year limited product warranty, 5-year limited finish warranty
Please
email us for pricing.
As part of our email security, once you email us, you will
be required to verify your email address before your email is delivered to
us. This is only required once)
|
We will need to know
the following information. |
|
1 |
Project Name |
|
2 |
Project Address
|
|
3 |
Your Phone Number
|
|
4 |
Module Manufacturer
|
| 5 |
Module Model |
| 6 |
Number of Module Rolls
|
| 7 |
Number of Module Columns
|
| 8 |
Number of Arrays
|
| 9 |
Number of Modules
|
| 10 |
Total Length and Square
Footage of roof area available |
 |
Components
RapidFoot:
1. 3/8" x 1-1/4" bolt
2. 3/8" x 1/8" x 1-1/2" washer
3. Clamp bar
4. EPDM washer
5. Standoff
6. Rapid top plate
7. Rapid base plate
Accessories:
8. Flashing
9. Concealor screw
10. Ferrules (Note: For concrete roofs, Scru-lead anchors
must be used.)
|
|